Melt Intercalation in Montmorillonite/Polystyrene Nanocomposites

Experimental Investigation of the Effect of the Bubble Cone on the Cooling Jets used in the Blown Film Manufacturing Process

Molding of Thin Sheets Using Impact Micro-injection Molding

3D Finite Element Simulation of Processing of Generalized Newtonian Fluids in Counter-rotating and Tangential TSE and Die Combination

An Improvement on Design of Sheet Extrusion Dies

Water Penetration Stability in Water Assisted Injection Molded Symmetric Ribs

Organic-Inorganic Hybrid Material Synthesis by on Line Coupling Twin Screw Extruder with a Microwave Oven

A New Plasticating Model for Amorphous and Semi-crystalline Polymers in Single Screw Extruders

Optimization of a Flat Die Including Elongational Viscosity Effects

Simultaneous Biaxial Stretching of Polypropylene Resins of Varying Tacticity
Part II: Film Morphology and Properties

Experimental Study on Factors Influencing Throughput Rate and Process of Polymer-Mineral Filler Mixing in a Twin Screw Extruder

Assessment of the Degree of Mixedness of Filled Polymers
Effects of Processing Histories in Batch Mixer and Co-Rotating and Counter-rotating Twin Screw Extruders

Experimental Study on the Filling of a Micro Injection Molding with Cylindrical Dot Patterns

The Gloss of Injection-Moulded Recovered Polypropylene

Injection Moulding and Mechanical Properties of Recovered Polypropylene

On PVT and Rheological Measurements of Polymer Melts
Correction of the Hole Fraction-Viscosity Relationship

Advanced Finite Element 3D Injection Molding

External Calibration in PA12 Tube Extrusion
Part I: On-line Draw Ratio Measurement and Lubrication Estimate for Determination of Tensile Properties

Two Dimensional Description of Pressure-Throughput Behaviour of Newtonian Materials Considering Wall Slippage Effects

Experimental Studies and Modeling of Development of Dispersion and Fiber Damage in Continuous Compounding

Using Multi-Objective Evolutionary Algorithms to Optimize Mechanical Properties of Injection Molded Parts

3D Simulation of Gas Assisted Injection Molding Analysis of Primary and Secondary Gas Penetration and Comparison with Experimental Results

Effect of Material Species on Flash Generation of PPS/GF Composites

Microcellular Injection Molding

Non-linear Crystalline Spherulitic Growth Behavior for LLDPE

Mold for Manipulation Microstructure Development

Preparing of Homogeneous Solution of Ultrahigh Molecular Weight PAN

Viscoelastic Properties of Flexible Organic Fiber Composites

Algorithms for Two Gate Optimization in Injection Molding

Non-linear Viscoelastic Behavior of PVC Plastisol

Melt Fracture of Linear PE
A Critical Study in Terms of Their Extensional Behaviour

Drawability of As-spun PP Fibres

Design Sensitivity Analysis for the Optimization of the Injection Molding Process

Preparation and Characteristics of Reactive Blends of Phosphate-containing Maleimide and Epoxy

Investigation of the Cooling Jets Used in the Blown Film Process

Simultaneous Biaxial Stretching of PP Resins of Varying Tacticity
Melting and Deformation Behavior

Easy Tear Multilayer Film of Biaxially Oriented PA6/MXD6 by Double Bubble Tubular Film Process

Rotational Moulding of PVC Plastisol
Modelling of Initial Stages of Gelation